Cambridge Audio DacMagic Plus User Manual download pdf (Page 30)

The DacMagic Plus can be sited in two different positions, as shown in the accompanying diagram.

It can be placed horizontally by tting the four small individual feet, or vertically by using the large

rubber ‘foot’. Power on the DacMagic Plus using the On/Off button on the front panel. After 4-5

seconds, the unit will unmute and the current Source and Filter type will be shown by the front

panel LEDs. Using the Source button on the front panel, select the appropriate digital input, i.e. USB,

Digital 1, Digital 2 or Ext, that you wish to listen to.

Switch on the external source, e.g. CD player, DVD player, etc. The sampling frequency of the Digital

Input will be displayed on the front panel (e.g. for a CD player – 44.1kHz).

Momentarily press the Filter/Phase selector button to cycle between three

different lter modes. Start playback of the source equipment. The DacMagic

Plus will output analogue audio from the Unbalanced/Balanced outputs

upsampled to 24-bit/384kHz. A ‘raw’ S/P DIF co-axial and TOSLINK optical

digital output is also provided. These outputs can be used to connect a

compatible digital recorder, e.g. CD-R/MD, etc.

The DacMagic Plus is compatible with Digital Stereo LPCM of a sampling

frequency between 32-192kHz.

Note: Being a stereo device, this unit does not decode 5.1 Dolby Digital or DTS

Bitstreams from a DVD player, etc. When receiving a multi-channel digital input,

the analogue audio outputs are muted. However, a 5.1 DD or DTS Bitstream will

pass-through to the digital outputs

Operating instructions

Horizontal placement Vertical placement

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

No comments

Cambridge Audio DacMagic Plus User Manual Page 30