Cambridge-audio DR30 User Manual download pdf (Page 14)

Connections

SW L

Digital

Outputs

2.1 Channel Audio Out

Trigger In

12V @ 30mA

Tip +ve

On Off

Loudspeaker Terminals

Right Left

FM 75ΩAM Loop 300Ω

CD DVD Aux

12V @ 30mA Tip +ve

CD DVD AUX

Out

Tun er

Trigger Out

DD30 Dock

Power AC

Power

Rec OutSub Audio In

Trigg er In

12V @ 30mA

Tip +ve

Audio Out

Loudspeakers

DD30 dock *

* iPod not included

Powered

subwoofer

(optional)

Sonata DV30

Sonata CD30

Note: Do not plug in the mains power lead or turn on the unit until all connections

have been made.

Loudspeakers

Check the impedance of your speakers. Speakers with an impedance of between 4

and 8 Ohms are recommended.

The red coloured speaker terminals are positive (+) and the black speaker terminals

are negative (-). Make sure correct polarity is maintained at each speaker connector

or the sound can become weak and “phasey” with little bass.

Prepare the speaker cords for connection by stripping off approximately 10mm (3/8”)

or less of the outer insulation. More than 10mm could cause a short circuit. Twist the

wires tightly together so there are no loose ends. Unscrew the speaker terminal knob,

insert the speaker cable, tighten the knob and secure the cable.

Note: All connections are made using standard loudspeaker cable. If an active

subwoofer is used, connect via a standard single RCA/phono cable (often referred to

as a 'Sub-Link').

DD30 docking station

Connect the supplied DD30 docking station to the connector located at the rear.

Active subwoofer In/Out

Connect the output to an active subwoofer using a standard RCA/phono cable (if

required). The input allows the Sonata AR30/DR30 to pass through the subwoofer

output (LFE) of an attached Sonata DV30 DVD player.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments

Cambridge-audio DR30 User Manual Page 14

Comments to this Manuals